1300 000 734
Polyphaser Lightning Protection

Polyphaser Lightning Protection

Coaxial Protection

Lightning damages equipment at radio communications sites every day. Although lightning is a DC pulse, the time from zero current to peak current can be very fast. When lightning energy travels through a coaxial cable, there is a slight propagation delay that occurs due to the unbalanced inductances of the shield and centre conductor, and the centre conductor’s capacitive relationship through the dielectric to the shield. The higher-frequency shield energy will arrive at the equipment first, followed by the centre conductor energy. Since the pulse energy arrives at different times, a differential voltage occurs. A properly designed coaxial protector equalises this potential difference, which prevents current flow and therefore damage to the site’s equipment.

However, the choice of a standard gas tube type coaxial protector without DC blocking may not offer the user complete protection. The fast rise-time lightning pulse can produce over 1000 Volts across the gas tube before the gas can ionise and become conductive. Since there is no DC blocking mechanism, this high voltage is applied directly to the equipment input before the gas tube turns on.

A quarter wave stub coaxial protector creates a band-pass filter, at a frequency determined by the length of the quarter wave coaxial section from the horizontal centre conductor to the grounded base. However, if the equipment input is DC-shorted, the quarter wave stub can allow significant divided DC and low frequency energy to flow towards the equipment input.

A “DC blocking mechanism” inside the protector (no DC continuity through the protector) will prevent harmful levels of throughput energy from reaching the equipment. RFI stocks and distributes the patented PolyPhaser DC-blocked coaxial protector line, which has the lowest throughput specifications in the industry.

There is also a series of PolyPhaser coaxial protectors that block DC in the RF path to the equipment, and either inject, pass through, or pick off a specified DC voltage on the feeder’s coaxial cable centre conductor. This series of protectors is particularly suited to applications requiring DC to be passed up the coaxial feeder cable to power tower-top amplifier electronics.

Remember that no matter how good your lightning protector is, it’s not a fuse. It still needs to be correctly installed and connected to a suitable grounding system. RFI offers a complete range of products to protect your system, including the coaxial protector, grounding rods, copper strapping and grounding kits for the feeder cables.

Polyphaser Quick Reference Frequency Chart

Transtector Signal Surge Protection Solutions

Signupto RFI newsletter